unknown

asked Feb 9, 2003 at 7:06am
Ibm IBM Laser Printer 4019

Ibm 4019

I get error code 9 and when I press the check button I get a 7 but I can't find anywhere what the error is or what needs to be fixed.

Scott
Have you checked our error code pages?
by moe on Feb 9, 2003 at 12:05pm Add comment
Thanks Moe

I did check out the error codes like you said but didn't find anything on IBM printers. Also Checked out the Lexmark error codes but there is nothing there either. Any other suggestions on where to find them.

Scott
by unknown on Feb 13, 2003 at 5:01am Add comment
Check the fan.
by Anonymous on Feb 13, 2003 at 5:51am Add comment
More importantly, check the plastic bracket that holds the fan. When you open the top, it's inside the lid on the left side. The plastic posts that hold the assembly in are bad about breaking. The fan is just trapped in bracket by the mounting posts being fastened to the frame. When they break, the fan comes dislodged and cannot turn.
by david belton on Feb 13, 2003 at 6:01pm Add comment
Yep! Fan bracket broken. Take plastic cover (top) off and you can get to bracket. I used CoolGlue (great for everything) to repair bracket. I am back in business. Great site!
by unknown on Feb 26, 2003 at 9:53am Add comment
Glue won't hold it for very long. It will fail again soon. Better go ahead and obtain a replacement part. I've tried everything from epoxy to silicone to fix these. Nothing I've ever used seems to last more than a week or two.
by david belton on Feb 26, 2003 at 3:19pm Add comment
I used a gray epoxy material and built up the plastic at the break points and it holds well. Disadvantage is that you have to completely take the part off and let it setup with just the right angles. probably better to use the glue, then go over it again with an epoxy compound to build up the thin part. I've also used 20 gage wire looped below the part and then twist tightened. had to cut some clearance on the cover, but that machine lasted about 9 months and two toner cartridges at work before being retired.
by unknown on Aug 13, 2003 at 10:34am Add comment
Superglue and baking soda. The baking soda acts as an instant accelerator and a hardener. It makes an instant plastic that you can file, shape or whatever you want. Has pretty good strength. You can build it up in layers by applying more glue and baking soda.
by moe on Aug 13, 2003 at 5:02pm Add comment
No tip... just congrats for keeping a 4019 running for so long.
by Spose on Aug 19, 2003 at 7:14am Add comment