asked Dec 10, 2014 at 12:40am
Hp HP LaserJet P3005DN

Firmware error HP p3005DN


During a firmware update on a HP P3005DN laserjet (only USB and network) the USB cable is disconected.
Now the printer runs through it's selfcheck of the memory and then during startup stops with the message "5/6 B/F"
Using a apple I am not able to resent the firmware with the LP command via USB since the printer does not respond.
Is there a software tool availible (windows / apple) to force the firmware to the printer?
I already performed a cold reset (and NVRAM) and this does also not make any change.

Thanks for your support.
If the usb cable was disconnect during you upgrade procedure, your formatter board is toasted. Search the forum for the thread of baking the board, if that not help you have to replace the formatter board.
by printertech_us on Dec 11, 2014 at 11:27am Add comment