rwmol

asked Apr 14, 2014 at 6:36am
Hp HP DeskJet Plus

HP LaserJet llP Plus Warm Up

I ordered and replaced the High Voltage Power Supply. Now, the printing process won't go beyond 02 WARM UP.

Is there something I may have goofed up or possible faulty power supply?
The hv power supply is not tested during warmup. Only time it comes into play is during print. Make sure all the connectors are firmly seated.
by moe on Apr 14, 2014 at 8:02am Add comment
Thanks moe.

There are disadvantages of being old....screwing up.

The advantage? Plenty of unused time in my day to find the screw up.
by rwmol on Apr 14, 2014 at 8:21pm Add comment
There must have been a loose connector as you stated in your reply. It now prints but there's smearing the full length and width of the page. Probable cartridge problem?

BTW: I didn't receive an email with your reply. Even though the box was checked.
by rwmol on Apr 15, 2014 at 2:25pm Add comment
The only cartridges available are remanufactured ones. Some remanufacturers replace the drum wiper blades, some don't as it's a lot of work. From your description, the wiper blade went bad. If the toner streaks are visible on the drum in the cartridge, that would be the cause.
by moe on Apr 15, 2014 at 2:36pm Add comment