dt_trader

asked Jun 6, 2007 at 2:43pm
Hp HP LaserJet 1200

HP LaserJet 1200

Printer
HP Laserjet 1200
Connected to Windows XP MCE machine via USB port

Problem:
Printer not responding to print command

Light status on the front panel
All 3 linghts stays on solid.(not flashing)

printer makes normal starting noise at start up and then
three linghts alternates and then goes solid.

tia for any help... HP support is no help
Do you want a service manual for this printer? It has all these codes etc. Email [email protected] and I will email it. pdf format 9 Mb
by lyleneander on Jun 7, 2007 at 4:26pm Add comment
Try this link - http://h20000.www2.hp.com
And tell us what is a Secondary light patterns.

Good Luck,
YP
by Ypshec on Jun 7, 2007 at 5:33am Add comment
Thanks for replying.
I tried what you suggested and here are the results.

Innitial start up all 3 lights alternates and then they all go steady ON.

When I push and hold the Big(green) light that one goes out but
the other 2 small lights stays on steady.

Thanks.
DT
by dt_trader on Jun 7, 2007 at 6:20am Add comment
DT,
You have the laser beam error.
It could be laser-scanner problem or broken pin on top of door that push black laser flag when you close the door.
Good Luck,
YP
by Ypshec on Jun 7, 2007 at 7:01am Add comment
thanks..
Can you throw some light on which broken pin on the top door you are talking about please ?

Thanks again.
DT
by dt_trader on Jun 7, 2007 at 7:09am Add comment
Ypshec,

I just checked the maintenance manual.

Secondary error code of attention and ready on solid is a main motor error.

Ready light only is a laser/scanner error.

Go light only is a beam error.

DT,

Refer back to the items DMZ and I listed in response to your other post.

by Stephen on Jun 7, 2007 at 8:53am Add comment
oh ok thanks.
by dt_trader on Jun 7, 2007 at 9:01am Add comment
sure.... thanks. I emailed you from my yahoo email ID. Please send it at that email address.

Thanks again.
DT
by dt_trader on Jun 8, 2007 at 3:45pm Add comment
DT and others.

I have just found a document listing the secondary error codes for the LaserJet 1200 & 1220.

The service manual and the document have different meanings assigned to some of the codes.

At this point it looks like the service manual is in error.

I have documented the secondary codes in the following thread:

http://www.fixyourownprinter.com/forums/printer/48243

ST
by Stephen on Jun 8, 2007 at 5:30pm Add comment
thanks for your help.
I will post the outcome.

thanks again.
DT
by dt_trader on Jun 10, 2007 at 8:07am Add comment
I couldn´t find secondary code for Ready light Off Attention light On Go light On
by TECNOMART on Oct 20, 2007 at 8:41am Add comment