unknown

asked Mar 11, 2004 at 8:50am
Epson Epson Artisan 810

Paper loading

Epson 810. Paper wont fully load to print head. stops after being pushed through about 2cm
Tony: If the paper looks like it is starting to feed-in crooked or at an angle, then its possible that there may be a foreign object thats actually blocking that Paper Entrance Area or stalling the paper as it tries to feed-in. Remove all the paper and use a flashlight to look carefully into the paper feed-in area. Look for a pen, pencil, push pin, paper clip, candy, etc. If you can't see anything, then actually pick your printer up and turn it so the paper opening is facing down and shake it a little, side to side. Your trying to dislodge anything that might be stuck in the paper entrance area. If nothing falls out, then turn it back over and use the flashlight to once again look inside that area. Sometimes you'll see an object that may have moved over into view while you were shaking the printer. Any foreign object might block the paper from actually being able to move forward, so then the printer thinks there is no paper installed. You may have to even remove the Top Cover to be able to get a better view of that paper feed area. Even if there is not a foreign object stuck in that area, with the top cover off, you might just possibly see what the problem is and even be able to correct it...Good Luck! Denny Conway
by Denny Conway on Mar 11, 2004 at 9:56am Add comment