Daveed

asked Sep 25, 2019 at 4:16pm
Konicaminolta Konica-Minolta Bizhub C250

BizHub C250 Error code 3001

HI, the issue is that the paper comes up all the way to the fuser unit and then stops 1 inch above the fuser. In the jam history I read code 3001. Any answer?

Thanks

The leading edge of the paper does not block the Exit Sensor (PC2) even after theDetection oflapse of a given period of time after the Registration Roller Clutch (CL1) has beenmisfeed at 2ndenergized.Image TransferThe Registration Roller Sensor (PC1) is not unblocked even after the lapse of asectiongiven period of time after it has been blocked by the paper.

The controller senses the time of paper passing, from the tray take to its exit from the fuser, it is convenient to clean sensors, pick up, and any intermediate roller, including the fuser, if the time between the paper take and output is greater than stipulated, printing stops regardless of where the printed sheet is.

I await your comment, best regards

by Laserone on Nov 5, 2019 at 2:49pm Add comment