[email protected]

asked Sep 5, 2015 at 5:26pm
Konicaminolta Konica-Minolta Bizhub C550

newly installed imaging units not working

My old imaging units timed out and i replaced with genuine Konica Minolta imaging units but they wont run. error message says 'incorrect imaging units'. What do I do?

I don't know if this will work after you get the message. You can make the IU's continue to run until you decide to replace them; on, possibly all, of the current color models of Konica Minolta. The machine will continue to ask for the IUs, until you upgrade the firmware. But you can set the machine to "NO STOP" in service mode. It works on C252, C350, C451, C550, C353, C253. Then when you start to see lots of P-22's and P-21's in the warning history, time is almost up!!! The IUs will go about twice the normal life!!! After the firmware has been installed, the message on the control panel disappears (AFTER you change the setting in the software switch setting mode.) The exact procedure is under proformance enhancements in the technical bulletins area of the KMBS website. Failing that there are chip resetters available. https://www.youtube.com/watch?v=V3Op6IzvUkc
by moe on Sep 6, 2015 at 5:14pm Add comment

hello my name is kosto, i have also the same problem, i have konica c650 saying incorrect imaging unite is set what the problem , the imaging unite is black

by Kosto on May 26, 2018 at 2:13am Add comment